Geofences Archives - Iotplot.com

User Guides.

Using Geofences

by | | IoTplot Support, Using Geofences, Geofences

Apart from the Geofences tab, you can see geofences on the map on other tabs, use them on the Monitoring tab, in notifications, reports and routes. Geofences can also be displayed in unit tooltips if the Presence in geofences option is enabled in the user settings....

Managing Geofences

by | | IoTplot Support, Managing Geofences, Geofences

Managing geofences consists of: performing actions from the list of geofences: editing, copying, deleting; working with geofences on the map; viewing information in the geofence tooltips. List of geofences By default, geofences are listed in alphabetical order. To...

Creating Geofences

by | | IoTplot Support, Creating Geofences, Geofences

To create a geofence, follow the steps below. Click New on the Geofences tab. Select the geofence type: polygon, line, or circle. Map the geofence. Specify the geofence properties. Click Save to save the geofence or Clear to start mapping the geofence again. To...

Import Geofences

by | | IoTplot Support, Import Geofences, Geofences

You can Import geofences to the portal. This can be useful if you already have your customers added as a map layer in some third party application, and would like to import their locations to the portal map. This not only shows them on the map, but can also be...

Geofence Properties

by | | IoTplot Support, Geofence Properties, Geofences

You should specify the properties of the geofence when creating it. Later, you can edit them. There are two ways to open the geofence properties: by clicking on the icon in the list of geofences; by clicking on the geofence on the map holding down the Ctrl key. The...

Groups of Geofences

by | | IoTplot Support, Groups of Geofences, Geofences

Geofence groups are used to combine geofences according to certain criteria. To open the list of groups, use the switch at the top of the workspace. Creating geofence groups To create a geofence group, follow these steps: Switch to the Groups mode. Click New. Select...

« Older Entries